Off-White 12.5 mm / 0.49 in Plastic Cap 54 System Snap Fasteners 100 Sets ERC00125PLKBeyaz

These 12.5 mm / 0.49 in off-white plastic cap snap fasteners are designed for garments and textile products that need a practical closure with a softer visible surface than a fully metal snap. The off-white plastic cap remains visible on the face of the product, while three stainless silver lower components form the working snap mechanism.

Off-white is less bright than optic white and can coordinate well with natural cotton, cream, neutral and muted pastel fabrics. It should not automatically be treated as ecru. For colour-critical collections, compare a physical snap with the actual fabric before approving production.

When is this snap a suitable choice?

Choose this snap for babywear, children’s garments, bodysuits, rompers, shirts, sleepwear, aprons and lightweight textile accessories where a 12.5 mm closure and a non-metallic visible cap are desired. Its 20L format offers a noticeable but relatively compact closure point.

This is not a fully plastic snap. Only the visible cap is plastic; the socket, stud and post are metal. If your specification requires plastic in every component, compare the alternatives in the plastic snap fasteners category.

Four-component 54 System construction

One complete snap consists of an off-white plastic cap, socket, stud and post. The pack contains 100 complete sets, equivalent to 400 individual components. Keep all components within the same 54 System; parts from other snap systems should not be mixed.

Setting die and press requirements

Install the snaps with the matching 12.5 mm / 0.49 in plastic-cap 54 System snap setting die. The correct cap cavity supports the plastic surface and helps keep the lower components aligned during pressing.

A compatible manual hand press machine can be used after confirming the die connection. Snap dies, presses, punching tools and reinforcement materials are not included in the snap pack.

Checks before repeat production

• Confirm the 12.5 mm / 0.49 in cap measurement and 54 System construction.
• Use a die designed to support the plastic cap profile.
• Check that the die thread matches the press or setting machine.
• Test thin, stretch or loosely woven fabrics with appropriate reinforcement.
• Inspect cap alignment, closure feel and the reverse side after pressing.
• Complete wash and use testing under the finished product’s actual conditions.

Typical applications

• Baby bodysuits and rompers
• Children’s clothing
• Shirts, sleepwear and light garments
• Aprons and lightweight home textiles
• Alteration and repair work
• Sampling and small-batch production

Selection warning: Do not select the snap by cap diameter alone for heavy jackets, rigid multilayer materials or high-stress fastening points. Fabric construction, reinforcement, component height and expected pulling load must be assessed through a sample installation.

Frequently Asked Questions

Does the pack contain 100 pieces or 100 complete sets?

It contains 100 complete snap sets. Because each set has four components, the pack contains 400 individual components in total.

Is the whole snap made of plastic?

No. The visible off-white cap is plastic. The socket, stud and post are stainless silver metal components.

Which setting die should be used?

Use a die compatible with 12.5 mm / 0.49 in plastic-cap 54 System S-spring snaps. Cap profile and system compatibility must both be checked.

Are the setting die and press included?

No. The pack contains only the snap components. The setting die, press and auxiliary tools are purchased separately.

Are off-white and ecru the same colour?

No. Off-white, ecru and optic white are separate colour choices. A physical sample comparison is recommended when an exact fabric match is required.

Should I test the snap before production?

Yes. Test the snap on the actual material and check alignment, holding performance, closure feel and the appearance of both fabric surfaces.